- #Nissan datascan ii for key program how to#
- #Nissan datascan ii for key program install#
- #Nissan datascan ii for key program 64 Bit#
Optional Security Card-Type A Kit must be approved security professional to purchase When the replacement module is installed in an applicable vehicle for any reason, it will need to be programmed. Depending on the model and model year, replacement modules come WITHOUT software. September 2013 Nissan and Infiniti began the phase-in of “blank” service part ECMs and TCMs. Supports ECM reprogramming on most 1999 model year and later and some TCM and ABS/VDC reprogramming. Nissan Consult 3 is a diagnostic software special for Nissan,support all the models of the Nissan and Infiniti from 1996 up till now, with all Consult II & III functions.It can support all Nissan car,Infiniti carand Nissan GTR. Scanning, but when trying Ecu programming, the Program buttons I tried several versions of Consult 3 plus software, they worked fine for While programming, mine started out at 13.5 but after a few minutes dropped Make sure your power supply can maintain system voltage Then just follow the programming steps in Consult 3 plus as thereĪre quite a few. Then copy over the Dat and Csv files into the ReproProgrammingįolder. ReproProgramming folder to another location, then delete all files in thatįolder.
#Nissan datascan ii for key program install#
Just run the 4 setups, after install completes, copy and save the 10 gigs in the
#Nissan datascan ii for key program 64 Bit#
Nissan Toughbook and VI2, also works with Dell D630 32 or 64 bit W7. I was able to update 2013 Altima 2.5 ECU using this software and genuine That’s not to say that it will work if you do not have the correct calibration file in the reprogramming folder on the C drive. Add the following line to the DiagnosticTool.ini fileĪlso make sure system management access_mode is set to 1. Or if you have money to waste buy the reprogramming card and the NATS card.
#Nissan datascan ii for key program how to#
any body knows how to activate it?Ī : you need to edit the file DiagnoticTool.ini to enable reprogramming and also IMMO. Q : I tried to reprogram the ABS module for a 2009 Nissan Murano but reprogramming option was disabled(Gray). Q : So which version is able to programming key without security card ?Ī : 72.20 is your bet. Q : Is the any one can say about programming key without security card ? is it possible or not ? Welcome to SAU Community, like most online communities you must register to view or post in our community, but don't.įor sake of security, you’d better use the link Nissan Consult Software Welcome to SAU Community. Vehicle reprogramming requires the use of the following: Nissan validated J2534-1 device. For Engine and Transmission control unit reprogramming and VIN writing capability on 2020 MY & newer, please use CONSULT-III plus or CONSULT-III plus R2R software.
Nissan DataScan II software has been tested on following cars: Infinity FX35 (VQ35DE). Not all Consult II cars are supported by this software. You must have an OBDII connector like the one below to be able to use this software. Nissan DataScan II software works on a range of Nissan Consult II cars.